RAM Memory Support
694XT1 - ACORP
Intel Socket 370, VIA C3 Processor, VIA 694X + 686B, FSB 66/100/133 MHz, AT, SDRAM, AC'97 Sound, AGP 4X, Ultra DMA 66/100, WOA, WOM, WOL
The VIA Apollo Pro133 chipset is based on an innovative and scaleable architecture with proven reliability and performance. It is a two-chip set consisting of the VT82C694 North Bridge Controller and the VT82C686B South Bridge Controller, as shown in the<
FSB 66/100/133 MHz
Frontside bus: the bus within a microprocessor that connects the CPU with main memory. The so-called dual independent bus (DIB) architecture allows a processor to use both this and the backside bus (which connects the CPU and the Level 2 cache) simultaneo
SDRAM 100/133 MHz
Synchronously DRAM :A memory technology that run synchronously to the system clock is capable of running at 100 or 133MHz ; it is more suitable to the high-speed memory and faster than conventional EDO memory.
2 Channel AC’97 Sound
Versatile I/O Capability
Ultra ATA/100 - expected to be the final generation of Parallel ATA interface before the industry completes its transition to Serial ATA - was announced in 2000. Also referred to as Ultra DMA mode 5, the new specification uses the same 40-pin, 80-conducto
Form Factor AT
The predominant motherboard form factor since the mid-1990s. It improves on the previous standard, the Baby AT form factor, by rotating the orientation of the board 90 degrees. This allows for a more efficient design, with disk drive cable connectors near
PCI x 3
In its original implementation PCI ran at 33MHz. This was raised to 66MHz by the later PCI 2.1 specification, effectively doubling the theoretical throughput to 266 MBps - 33 times faster than the ISA bus. It can be configured both as a 32-bit and a 64-bi (IRQ’s) to be shared. This is useful because well-featured, high-end systems can quickly run out of IRQs. Also, PCI bus mastering reduces latency and results in improved system speeds.
Intel's release of version 2.0 of the AGP specification, combined with the AGP Pro extensions to this specification, mark an attempt to have AGP taken seriously in the 3D graphics workstation market. AGP 2.0 defines a new 4x-transfer mode that allows four l benefit wasn't seen until the implementation of 133MHz SDRAM and Direct Rambus DRAM (DRDRAM) in the second half of 1999. AGP 2.0 was supported by chipsets launched early in 1999 to provide support for Intel's Katmai processor.
RAM Memory Support
Manufacturer - downloads drivers, manuals and BIOS : ACORP
Prodejce v ČR : Možnost vložení odkazu prodejce - info zde
Recenze : Odkazy na recenze vložíme po dohodě
Problems, experience, griffs.....: